DCD 00650-250 Dub-Wise Puller 2-1/2 Inch Duct
Available*
Item # 30510560
Model # 00650-250
$426.18
financing available. Learn More
* Notes on Availability:
If item is in stock, it will ship same day.
Lead times vary, contact us for more info.
(Images may not be of the actual item being sold.)
- Product Description
- You Might Also like
- Recently Viewed
Generic
Class
Group
Type
Manufacturer
LOT
Pull Eyes
Tools
Line Construction- Placing
Eyes- Cable Pulling
DCD Design And Manufacturing Ltd
Warning: This product can expose you to chemicals, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.govProduct Description
Dcd Design/Cable Spinning Equipment 00650-250 Dub-Wise Puller 2-1/2" Duct New
These Products Are Designed To Install Polyethylene Ducting Using Expanding Jaws To Grip The Inside Diameter Of The Duct While The Outside Diameter Is Prevented From Stretching By A Permanent Outer Sleeve On The Puller. The Outer Sleeve Also Provides A Complete Seal Around The Ducting Preventing Any Fluids Or Contaminants From Entering Either The Duct Or The Pulling Eye. The Pulling Head Is Manufactured From Alloy Steel And Is Designed To Protect The Mechanism From Heavy Knocks Or Side Loads. It Is Also Fully Sealed To Prevent Any Fluid Entry. Care Should Be Taken At All Times Not To Exceed The Yield Value Of The Ducting Since This May Cause Permanent Deformation To The Duct As Well As Loss To The Integrity Of The Polyethylene. These Duct Pullers Are Installed Quickly And Easily And Require No Special Tooling. A New Tooth Profile Makes Removal Much Easier Than The Earlier Models. Duct Wall Thickness Is Normally Designated By An Sdr Value. The Lower The Sdr Value, The Heavier The Wall Thickness. These Products Can Be Used On Sdr 9 Through Sdr 17 Ducting And Schedule 40 Pipe.
These Products Are Designed To Install Polyethylene Ducting Using Expanding Jaws To Grip The Inside Diameter Of The Duct While The Outside Diameter Is Prevented From Stretching By A Permanent Outer Sleeve On The Puller. The Outer Sleeve Also Provides A Complete Seal Around The Ducting Preventing Any Fluids Or Contaminants From Entering Either The Duct Or The Pulling Eye. The Pulling Head Is Manufactured From Alloy Steel And Is Designed To Protect The Mechanism From Heavy Knocks Or Side Loads. It Is Also Fully Sealed To Prevent Any Fluid Entry. Care Should Be Taken At All Times Not To Exceed The Yield Value Of The Ducting Since This May Cause Permanent Deformation To The Duct As Well As Loss To The Integrity Of The Polyethylene. These Duct Pullers Are Installed Quickly And Easily And Require No Special Tooling. A New Tooth Profile Makes Removal Much Easier Than The Earlier Models. Duct Wall Thickness Is Normally Designated By An Sdr Value. The Lower The Sdr Value, The Heavier The Wall Thickness. These Products Can Be Used On Sdr 9 Through Sdr 17 Ducting And Schedule 40 Pipe.
