Joslyn J2245 Cable Suspension Clamp Fig 8 With Stringing Hook
Available*
Item # 55724820
Model # J2245
$39.68
financing available. Learn More
* Notes on Availability:
If item is in stock, it will ship same day.
Lead times vary, contact us for more info.
(Images may not be of the actual item being sold.)
- Product Description
- You Might Also like
- Recently Viewed
Generic
Class
Group
Type
Manufacturer
LOT
Clamp
Material and Supplies
Hardware- Screws- Bolts
Clamps
Maclean Power Systems
Warning: This product can expose you to chemicals, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.govProduct Description
Joslyn Hubbell Power Systems J2245 Cable Suspension Clamp Fig 8 With Stringing Hook New
These Clamps Are Used For Tangent Construction Or Angles To 10 Degrees. Clamps Accommodate 1/4 Inch Insulated Messenger. The Hook Is Provided For Stringing And Safety. The J2235 Is Designed For Normal Use. The J2245 Is Supplied With Two Clamp Bolts For Maximum Holding Strength In Areas Of Adverse Wind Conditions Or Where Longs Spans And Heavier Loads Are Required. Independent Clamping - Remains Tight If Pole Shrinkage Occurs. A 5/8 Inch Bolt Is Mounted On Pole With Hook Against Pole. The Square Nut Is Tightened Up Against The Hook And Left In A Square Position As Shown. Add A Minimum Of 3 Inches To Pole Diameter To Determine Length Of Bolt To Be Used. After The Cable Is Strung, The Nut Is Loosened And The Keeper Is Turned Around As Shown. The Cable Is Then Raised Up So That The Messenger Can Be Gripped Tightly In The Groove Of The Hanger By Tightening The Nut. Material: Ductile Iron - Hot Dipped Galvanized
These Clamps Are Used For Tangent Construction Or Angles To 10 Degrees. Clamps Accommodate 1/4 Inch Insulated Messenger. The Hook Is Provided For Stringing And Safety. The J2235 Is Designed For Normal Use. The J2245 Is Supplied With Two Clamp Bolts For Maximum Holding Strength In Areas Of Adverse Wind Conditions Or Where Longs Spans And Heavier Loads Are Required. Independent Clamping - Remains Tight If Pole Shrinkage Occurs. A 5/8 Inch Bolt Is Mounted On Pole With Hook Against Pole. The Square Nut Is Tightened Up Against The Hook And Left In A Square Position As Shown. Add A Minimum Of 3 Inches To Pole Diameter To Determine Length Of Bolt To Be Used. After The Cable Is Strung, The Nut Is Loosened And The Keeper Is Turned Around As Shown. The Cable Is Then Raised Up So That The Messenger Can Be Gripped Tightly In The Groove Of The Hanger By Tightening The Nut. Material: Ductile Iron - Hot Dipped Galvanized
